Kramer Electronics Ltd.
DIP-31
– Protocol 3000
34
Protocol 3000
The
DIP-31
Automatic Video Switcher can be operated using the Kramer Protocol 3000 serial
commands. The command framing varies according to how you interface with the
DIP-31
. For
example, a basic video input switching command that routes a layer 1 video signal to HDMI
out 1 from HDMI input 2 (ROUTE 1,1,2), is entered as follows:
•
Terminal communication software, such as Hercules:
The framing of the command varies according to the terminal communication software.
•
K-Touch Builder (Kramer software):
•
K-Config (Kramer configuration software):
All the examples provided in this section are based on using the K-Config software.
You can enter commands directly using terminal communication software (e.g., Hercules) by
connecting a PC to the serial or Ethernet port on the
DIP-31
. To enter
CR
press the Enter key
(
LF
is also sent but is ignored by the command parser).
Commands sent from various non-Kramer controllers (e.g., Crestron) may require special
coding for some characters (such as,
/X##
). For more information, refer to your controller’s
documentation.
For more information about:
•
Using Protocol 3000 commands, see
