ASPEN-32UFX Quick Start (P/N: 2900-300942QS REV 2)
P/N:
2 9 0 0 - 3 0 0 9 4 2 QS
Rev:
2
Scan for full manual
ASPEN-32UFX Quick Start Guide
This guide helps you install and use your
ASPEN-32UFX
for the first time.
www.kramerav.com/downloads/ASPEN-32UFX
to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check w
hat’s in the box
ASPEN-32UFX
Programmable 32 port 12G SDI Router
1 Set of rack ears
1 Quick start guide
1 Power adapter and cord
4 Rubber feet
Step 2: Get to know your ASPEN-32UFX
#
Feature
Function
1
RS-232 (G,Rx,Tx) Terminal Block Connector
Connect to a PC or remote controller.
2
POWER 12V DC Terminal Block Connector
Dual power supply for redundancy:
PS 1
– primary power connector
PS 2
– redundant power connector (optional).
Connect each power adapter into a separate branch circuit employing a
separate service ground.
3
RESET Button
Press briefly to restart the system.
Press for 5 seconds to reset IP settings to factory default values.
The device powers up and loads the factory default values:
IP address: 192.168.1.39; Mask: 255.255.255.0; Gateway 192.168.1.1.
4
ETHERNET RJ-45 Connector
Connect to a PC via LAN and also used for firmware upgrade.
5
LOOP BNC Connector
Connect to the GENLOCK connector of the next unit in the daisy chain or
terminate with 75Ω.
6
GENLOCK BNC Connector
Connect to the GENLOCK source.
7
PORTS BNC Connectors (32)
Connect to sources and acceptors.
Step 3: Install ASPEN-32UFX
Install
ASPEN-32UFX
using one of the following methods:
•
Remove the three screws from each side of the unit, reinsert those screws through the
rack ears and mount on a 19" rack.
•
Attach the rubber feet and place the unit on a flat surface.
