Kramer Electronics Ltd.
AFM-20DSP
– Connecting the 20-Port Audio Matrix
11
Connecting AFM-20DSP-LE
Always switch off the power to each device before connecting it to your
AFM-20DSP-LE
.
After connecting your
AFM-20DSP-LE
, connect its power and then switch on the power to
each device.
Figure 7: Connecting to the
AFM-20DSP-LE
Rear Panel
To connect
AFM-20DSP-LE as illustrated in the example in
1. Connect the following audio sources to the PORT balanced mono 3-pin terminal block
connectors
(port I/O is set to 12x8 in this example):
▪
Microphones to ports 1 to 9.
▪
The audio output of the Kramer
VP-444
scaler to port 10.
▪
An MP3 player to ports 11 and 12.
2. Connect the PORT balanced mono 3-pin terminal block connectors
(port I/O is set to
12x8 in this example) to the following audio acceptors:
▪
Ports 13 and 14 to powered speakers (for example, Kramer
Tavor 6-O
).
▪
Port 15 to a power amplifier with speakers.
▪
Ports 16 to 20 to audio receivers.
3. Connect the RS-232 3-pin terminal block connector
to the RS-232 port on a
controller (for example, a laptop) to control the
AFM-20DSP-LE
.
4. Connect the ETHERNET RJ-45 port
to the Ethernet to control the
AFM-20DSP-LE
and use for firmware upgrade.
5. Connect the mini USB connector
to a control device (for example, a laptop) to
control the
AFM-20DSP-LE
.
6. Connect the power cord to the
AFM-20DSP-LE
mains socket
and to the mains
electricity (not shown in
7
7
15
16
17
19