Kramer 104LN, User Manual

Page: 10 / 14

104LN - Connecting the 104LN 7
4 Connecting the 104LN
Always switch off the power to each device before connecting it to your
104LN . After connecting your 104LN , connect its power and then
switch on the power to each device.
To connect the 104LN 1:4 Differential Video Line Amplifier , as the example in
Figure 3 illustrates, connect the following:
1. Connect a composite video source (for example, a satellite decoder and
receiver) to the INPUT BNC connector.
2. Connect the four OUT BNC connectors to up to four composite video
acceptors, as follows:

Connect the OUT 1 connector to video acceptor 1 (for example,
a video recorder)

Connect the OUT 2 connector to video acceptor 2 (for example,
a video display)

Connect the OUT 3 connector to video acceptor 3 (for example,
a video display)

Connect the OUT 4 connector to video acceptor 4 (for example,
a video display)
3. Adjust the output signal level and/or cable compensation equalization level,
if required.
4. If the image appears noisy, set the INPUT GROUND to either ON or FLOAT
to lower the noise level.
i