BEFORE FIRST USE
a) Before first use of this product, purge away air from the hydraulic system: open the release valve by
turning it counterclockwise. Pump several full strokes to eliminate any air in the system.
b) Check all parts and conditions, if there is any part broken, stop using it and contact your supplier
immediately.
c) If under plate (29) is not in the centre, loose the screw (23) slightly, then slide the under plate to the
position you need and tighten the screw.
OPERATIONG INSTRUCTIONS
WARNING! ENSURE THAT YOU READ, UNDERSTAND AND APPLY THE SAFETY INSTRUCTIONS AND WARNINGS
BEFORE USE.
• Place the heel block on bed frame, then insert workpiece onto the heel block.
• Connect the air inlet fitting into the shop air supply hose lock fitting, turn on the air valve (pistol) to let
the pump work until the ram nears to the workpiece, then turn off the air valve (pistol) When air source
is unavaliable, use the handle to pump.
• Align workpiece and ram to ensure center-loading.
• Turn on air valve (pistol) (or pump the handle) to apply load onto workpiece.
• When work is done, turn off the air valve (pistol) (or stop pumping handle), slowly and carefully remove
loadfrom workpiece by turning the release valve conterclockwise in small increments.
• Once ram has fully retracted, remove workpiece from bed frame.
• Disconnect the air inlet fitting from the air source.
MAINTENANCE
• Clean the outside of the press with dry, clean and soft cloth and periodically lubricate the joints and all
moving parts with a light oil as needed.
• When not in use, store the press in a dry location with ram and piston fully retracted.
• When press efficiency drops, purge always air from hydraulic system as described before.
• Check the hydraulic oil; remove the oil filler nut on the top of the reservoir, if the oil is not adequate, fill
with high quality hydraulic jack oil as necessary, then replace the oil filler nut, purge away air from the
hydraulic system.
3
