Kraftronic 972770, Manual

Page: 40 / 46

40
In case of contact with detergents: rinse with an abundance of clean water
Turn on the pressure washer. Pull trigger to operate unit. The liquid detergent
will automati¬cally mix with water, and be discharged through the nozzle. Apply
detergent to a DRY work surface, from bottom to top.
Allow detergent to remain on the surface for a short time before rinsing. Do not
allow detergent to dry on surface
Rinse with clean water under high pressure. On a vertical surface, rinse from the
bottom up, then rinse from the top down to avoid streaking. Hold nozzle 6-8” (15-20
cm) from the work surface, at a 45° angle.
When you have finished using the detergent injection system, fill detergent
bottle with clean water. Siphon water at low pressure for one minute, so that all
detergent is flushed through system. Remove detergent bottle, and rinse it until it is
thoroughly cleaned
Adequate information about the nozzles to be used, the danger of the kickback
force and the sudden torque on the spray assembly when opening the trigger gun;
Clogging of the spray tips causes the pump pressure to be too high and cleaning is
immediately required. You can clean the spray tips by carefully inserting a needle,
or a thin, sharp instrument (e.g. paperclip) into the tip to rid it of deposits.
Hold with both hands.
The trigger gun safety lock prevents the trigger from being engaged accidentally.
The safety feature DOES NOT lock trigger in the ON position.