KRAFT KF-DF260W, User Manual, Page: 23 / 36

23
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE
ХОЛОДИЛЬНИК
REFRIGERATOR-FREEZER
INSTALLATION
Location
When selecting a position for your unit you should make sure the floor is flat and firm,
and the room is well ventilated. Avoid locating your unit near a heat source, e.g. cooker,
boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption.
Extreme cold ambient temperatures may also cause the unit not to perform properly.
This unit is not designed for use in a garage or outdoor installation. Do not drape the unit
with any covering.
When installing the unit, ensure that 10 cm of free space is left at both sides, 10 cm
at the rear and 30 cm at the top of the unit. This will allow cold air to circulate around the
wine cooler and improve the efficiency of the cooling process.
Positioning
Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
CLIMATE CLASS Ambient temperature
N Sub Normal +10°C to +32°C
SN Normal +16°C to +32°C
ST Sub Tropical +16°C to +38°C
T Tropical +16°C to +43°C
Door Space Requirements
The unit’s door must be able to open fully as shown.
Levelling the Unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the door and magnetic seal alignments will not be covered
properly. Make sure that the foot touches the ground before use. Look down from the
top, clockwise and counterclockwise loosening, tightening.
Reversing the Door Swing
Reversing the Door Swing by professionals.
Cleaning Before Use
Wipe the inside of the Fridge/Freezer with a weak solution of bicarbonate of soda.
Then rinse with warm water using a damp sponge or cloth. Wash the baskets and
shelves in warm soapy water and dry completely before replacing in the Fridge/Freezer.
The external parts of the Fridge/Freezer can be cleaned with wax polish.