Kozy-World KWN185, User'S Operation And Installation Manual, Page: 7 / 23

Page 6
in high traffic areas
in windy or drafty areas
IMPORTANT : Vent-free heaters add moisture to the air. Although this is
beneficial, installing heater in rooms without enough ventilation
air may cause mildew formation from too much moisture content.
See National Fuel Code for Fresh Air for Combustion and
Ventilation.
This appliance may be installed in an aftermarket* manufacture
(Mobile) home, where not prohibited by state or local codes.
*Aftermarket : Completion of sale, not for purpose
of resale, from the manufacturer.
This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other gases.
CAUTION :
If you install the heater in a home garage:
Heater must be at least 18 inches above floor.
Locate heater where moving vehicle will not hit it.
Preparing For Installation
Select a location for the heater that will provide maximum exposure of the radiant
surface to the room, but will not be subjected to accidental contact.
Adequate clearance must be available around the air opening. See figures 1 & 2 for
clearances that must be maintained to the side walls, floor and horizontal surface
surrounding the heater.
Attaching Mounting Brackets To Wall
Note:Wall anchors, mounting screws, and spacers are in hardware package.
The hardware package is provided with heater
13"
2"
Minimum to top surface
of carpeting. Tile or other
combustible material
Right
side
36"
Minimum
CEILING
FLOOR
Left
side
Minimum
from
sides of
heater
Figure 1 Figure 2