1 5
TROUBLESHOOTING
ODS/pilot lights but flame is continu-
ous igniting and the main burner
couldn
’
t be lit.
1. Thermocouple connection loose at
control board
2. Pilot flame not touching thermocouple
which allows thermocouple to cool,
causing pilot flame to go out. This
problem could be caused by one or
both of the following
A) Low gas pressure
B) Dirty or partially clogged ODS/ pilot
3. Thermocouple damaged
4. Control valve damaged
1. Hand tighten the connectors.
2. A) Contact local gas company.
B) Clean ODS/pilot (
see Cleaning and
Maintenance
, page 13) or replace ODS/
pilot assembly
3. Replace thermocouple
4. Replace control valve
Burner does not light after ODS/pilot is
lit
1. Burner orifice clogged
2. Inlet gas pressure is too low
3. Burner orifice diameter is too small
4. Thermocouple leads disconnected or
improperly connected
5. Burners will not come in remote posi-
tion
1. C lean b urner (
s ee C le an in g an d
Maintenance
, page 13) or replace
burner orifice.
2. Contact local gas company
3. Replace burner orifice
4. Reconnect leads (
see wiring diagram
)
5. Replace battery in transmitter and
receiver
REMEDY
WARNING: Make sure that power
is turn off before proceeding....
WARNING:
Turn off and let cool
before servicing. Only a qualified ser-
vice person should service and re-
pair fireplace.
CAUTION: Never use a wire,
needle, or similar object to clean
ODS/pilot. This can damage ODS/
pilot unit.
W hen pressing the button of ignitor
button is pressed, there is spark at
ODS/pilot but no ignition
OBSERVED PROBLEM
POSSIBLE CAUSE
1. Gas supply turned off or equipment
shut off valve closed
2. Air in gas lines when installed.
3. Depleted gas supply
4. ODS/pilot is clogged
5. Gas regulator setting is not correct
6. Pilot electrode position is not correct
7. Wire is not correct or loosen
8 Gas valve is damage
1. Turn on gas supply or open equipment
shutoff valve
2. Press ON/OFF button again until air is
removed
3. Contact local gas company
4 Clean ODS/pilot (see Cleaning and
Maintenance, page 13 ) or replace ODS/
pilot assembly
5. Replace gas regulator
6. Replace Pilot
7. Check the wine and make wine correct.
8. Replace gas valve
No spark when press in ignition button
1. No power to heater
2. No battery in transmitter or battery
isn
’
t correctly assembly
3. The Control Knob is not on ELEC-
TRIC position
4. System halt
1. Check the electric power
2. Place or replace the battery
3. Set Control Knob to ELECTRIC position
4. Place the control knob of manual over-
ride on OFF position for at least 1 minute,
then turn to ELECTRIC position
NOTE: BEFORE YOU SWITCH TO
“
ELECTRIC
”
CONTROL LEVEL FROM MANUAL CONTROL,
YOU NEED TO TURN THE KNOB TO
“
OFF
”
LEVEL FIRST AND WAIT FOR ONE MINUTE,
THEN TURN THE KNOB TO
“
ELECTRIC
”
.
IN CASE OF
“
ELECTRONIC
”
CONTROL LEVEL DOES NOT WORK, PLEASE TURN THE
CONTROL KNOB COUNTERCLOCKWISE TO
“
OFF
”
LEVEL AND WAIT FOR ONE MINUTE.