UNPACKING
1. Remove top inner pack.
2. Tilt carton so that fireplace is upright.
3. Remove protective side packaging.
4. Slide fireplace out of carton.
5. Remove protective plastic wrap.
6. Hold the screen lift and pull forward.
7. Remove log set by cutting plastic ties.
8. Carefully unwrap log.
9. Check for any shipping damage. If fireplace or logs are damaged, promptly inform dealer where you
bought fireplace.
10. Remove eight screws and two bottoms of angle iron
PRODUCT IDENTIFICATION
Figure 1
–
Vent Free LP/NG Gas Fireplace
WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM HEATERS
Water vapor is a by-product of gas combustion. An unvented room heater produces approximately one (1)
ounce (30ml) of water for every 1,000 BTU
’
s (.3KW
’
s) of gas input per hour.
Unvented room heaters are recommended as a supplemental heater (for a room), rather than a primary
heat source (for an entire house). In most supplemental heat applications, the water vapor does not create
a problem. In most applications, the water vapor enhances the low humidity atmosphere experienced during
cold weather. The following steps will help insure that water vapor does not become a problem.
1. Be sure the heater is sized properly for the application, including adequate combustion air and
circulation air.
2. If high humidity is experienced, a dehumidifier may be used to help lower the water vapor content of
the air.
3.
Do not use an unvented room heater as the primary heat source.
6