GAS FIREPLACE INSERT SETUP
23
9.4 Control Board Removal
and Installation
WARNING: If burner and/or pilot have been burning, use
appropriate protection to avoid burns or damage to personal
property before removing any components. DO NOT OPERATE
THIS APPLIANCE WITHOUT THE SEALING GASKET (LOCATED
UNDER THE CONTROL BOARD) IN PLACE. IF GASKETING IS
DAMAGED, IT MUST BE REPLACED.
CAUTION: Check all connections for leaks with soapy water,
whether field or factory made.
9.4.1 Control Board Removal
1. Disconnect electrical power.
2. Locate the main shut-off valve upstream of the appliance
connector and close valve.
3. Remove safety barrier and glass frame assembly.
4. Remove log set.
5. Remove refractory panel set. Loosen screws securing
refractory clips on the baffle (2 each side) to remove left and
right panels.
6. Remove back burner assembly (2) screws each side.
7. Remove front burner assembly by lifting it up and off the front
burner orifice.
8. Remove (10) screws securing the control board on the left
side of the firebox.
9. Pull out control board out to reveal gas line to disconnect the
gas line flex tube from fireplace valve.
9.4.2 Control Board Installation
1. Place control board on the left side of the firebox and
reconnect gas line to fireplace valve.
2. Verify sealing gasket is in place. Secure board with (10)
screws previously removed.
3. Reinstall front burner by positioning the venturi over the front
burner orifice, and set into place.
4. Reinstall back burner. Position the burner tube venturi over
the back burner orifice and secure with (2) screws previously
removed.
5. Reinstall refractory panel set.
6. Reinstall log set.
7. Reconnect electrical power.
8. Reinstall the glass frame assembly and safety barrier.
9. Verify proper log placement, operation of fireplace, and any
electrical components.
ON
OFF
Figure 9.5, Control Board Removal and Installation
FRONT BURNER ASSEMBLY
BACK BURNER ASSEMBLY
