150Mbps Wireless N Router
55
5.
FAQ
1. I cannot access the Web-based Configuration Utility from the Ethernet computer
used to configure the router.
Check that the LAN LED is on. If the LED is not on, verify that the cable for the LAN
connection is firmly connected.
Check whether the computer resides on the same subnet with the router’s LAN IP
address.
If the computer acts as a DHCP client, check whether the computer has been assigned an
IP address from the DHCP server. If not, you will need to renew the IP address.
Use the ping command to ping the router’s LAN IP address to verify the connection.
Make sure your browser is not configured to use a proxy server.
Check that the IP address you entered is correct. If the router’s LAN IP address has been
changed, you should enter the reassigned IP address instead.
2. I forget Password (Reset the Router without Login)
Use a pencil to press the default button with a pencil until the SYS LED shining 3 times
(press about 10 seconds or a longer time) when it is working, then leave your hands, it will
restore settings to the factory configuration. The default password is
guest
.
3. I have some problems related to Connection with Cable Modem
Please follow the following steps to check the problems:
Check whether the DSL modem works well or the signal is stable. Normally there will be
some indicator lights on the modem, users can check whether the signal is ok or the
modem works well from those lights. If not, please contact the ISP.
Check the front panel of the Router, there are also some indicator lights there. When the
physical connection is correct, the Power light and the CPU light should be solid; the
WAN light should be blinking. If you use your computer, the corresponding LAN port light
should be blinking too. If not, please check whether the cables work or not.
Repeat the steps in
WAN Setup
Connect with Internet through DSL Modem.
4. I can browse the router’s Web-based Configuration Utility but cannot access the
Internet.
Check if the WAN LED is ON. If not, verify that the physical connection between the router
and the DSL/Cable modem is firmly connected. Also ensure the DSL/Cable modem is
working properly.
If WAN LED is ON, open the System Overview page of the Web configuration utility and
check the status group to see if the router’ s WAN port has successfully obtained an IP
