(3) DAY/NIGHT Setting
(i) COLOR
The camera always outputs color video signals (with IR cutoff).
(ii) B/W
The camera always outputs monochrome video signals (with no IR cutoff).
(iii) AUTO
The camera automatically switches the mode to output high-quality video during the daytime and
high-sensitivity monochrome video during the nighttime.
In AUTO mode, the GAIN setting is configured to either AGC or HYP-AGC.
If this mode is selected, you can press the E button to configure the SWITCH LEVEL (switchover
brightness level) setting as follows:
LEVEL setting: You can set the switchover brightness level.
DARK: The switchover brightness level is low.
MID: The switchover brightness level is between DARK and BRIGHT.
BRIGHT: The switchover brightness level is high.
MANUAL: You can manually set switchover brightness level.
MANUAL setting: When the LEVEL setting is configured to MANUAL, you can configure the
following settings:
COLOR
→
B/W: You can set the brightness at which the mode changes from DAY to
Night.
B/W
→
COLOR: You can set the brightness at which the mode changes from Night to
DAY.
(iv) REMOTE
You can switch the DAY/NIGHT mode by external operation. You can configure the B/W COLOR
setting by configuring (12) RS-485/day and night switching terminal 1-2 shown in Names and
Functions of Parts to Short or Open. Depending on the MAIN MENU (PAGE4/5) IR TRIG.POL setting,
the short and open statuses change as follows:
RS485 control / day and night switching
terminal 1-2
Short Open
IR TRIG POL
BRAKE
COLOR
B&W
MAKE B&W COLOR
(4) FLICKER-LESS
(i) OFF
This option should be selected in normal cases.
(ii) ON
When flicker is annoying under fluorescent light, select this option to fix the SHUTTER
setting to 1/100.
2-1-2. SHUTTER Setting
(1) When the SENSEUP setting is configured to OFF, the SHUTTER setting is enabled.