Kospel SB.INOX 200, Manual

Page: 25 / 40

25
PL;DE;FR;GB;RU-065_f.866
CW
ZG2
C
PG2
ZG1
PG1
ZW
ZB
NW
Connection to the central heating system
Unit must be fitted to the central heating
system by pipe unions. Install a supplied
plastic isolators between the pipe unions
and tank. The tank must be electrically
isolated from the hydraulic system by
using the supplied isolators to screw
to the couplers to prevent the galvanic
corrosion. A cut off valves must be in-
stalled after the pipe unions. A flow rate
of heating water must be high enough
to maximise unit efficiency (see techni-
cal data table). It concerns the forced
circulation installation (with a central
heating water pump). SW.INOX model is
equipped with one coil. SB.INOX model
is equipped with two coils for connec-
Connection to the water system must be performed according to binding norms of
hydraulic installation. The cylinder is a pressure appliance designed for connection to
the water supply system where the water pressure doesn’t exceed 0,6 MPa. If the water
pressure exceeds 0,6 MPa the pressure reducing valve before cylinder must be fitted.
Please follow the water connection instructions below:
- install the T-connection with 6 bar safety valve (e.g. ZB-4) and the drain valve
to the inlet fitting of cold water [ZW]. It’s forbidden to install a cut-off valve
(or any flow reducer) between tank and the safety valve and on it’s outlet.
The safety valve must be installed in that place to let you quickly see the
outgoing water,
- install the cylinder equipped with the safety valve to the water system,
- install the cut-off valve on cold water supply pipe.
Hot water outlet pipe must be connected to the ¾″ fitting, which is located in the up-
per part of the unit.
Each cylinder is equipped with ¾″ fitting for domestic hot water circulation connection.
tion to e.g. boiler and solar collector system. SWZ.INOX and SBZ.INOX models are
equipped with additional connectors for external heat exchanger.
GB
Connection to the water system