5
ENG-029B/p.351
The appliance should be moun-
ted in such a way that an easy
access is assured.
2
Fig.2 Non-pressure assembly to
the water heater to the water
mains
a) – water heater POC.Gb-5/2
b) – water heater POC.Db-5/2
[5] - hot water outlet
[9] - cold water inlet
[10] - connecting tubes (made of metal)
[11] - water supply
[12] - reduction from 1/2" to 3/8"
[13] - tap
Assembly
1. Mount the heater on the wall
according to two options given
below:
a) fix two (stretching) pins
ø
8 into
the wall with a 140 mm-distance
between them (fig.1a, 1b, 2a 2b),
- screw the fixing screws in such
a way that there will be no more
than a 4 mm-slot between a wall
and a screw head,
- hang the heater on the fixed
screws,
b) fix the special hanger to the wall
(fig.3 [14]) and hang the water
heater. In case of assembly of
the POC.Gb, a 712mm spacing
3
Fig.3 Installation of the water
heater POC.Gb-5/2 with
use of a hanger
[13] - tap
[14] - hanger
a) b)
between axes of fixing pins and the tap has to be kept (fig.3).
2. According to fig. 1 or 2 bring the domestic water and the electricity
supply, to the point where the heater is to be mounted. In the water
heater:
a) POC.G or POC.D connect cold water to the inlet pipe [3] accord-
ing to scheme on fig.1 and hot water outlet to the outlet pipe [4].
On the cold water inlet supply pipe a mandatory safety valve [6] has
to be installed with a rated pressure of 0,6 MPa.
b) Connect the POC.Gb or POC.Db heater to the tap (with metal tubes
fig.2a or flexible connectors (hoses)fig.2b) - placing gaskets on the nuts
beforehand. In case of POC.D, please, pay attention to the markings
on the tap and right connection of flexible connectors (fig. 5). Flexible
tap connectors has thread 3/8”– a reductor from 1/2” to 3/8” must be
used.
3. After connecting the appliance to water installation, open hot water
tap (red colour) and wait until the heater container is filled with water
(when water starts running from the tap).
4. Check connections for their tightness.
