3
ENG-029B/p.351
POC Luna inox - a small storage water heater is suitable for being assembled in a household, a sanitary room,
a laboratory, a workshop etc.
There are 2 versions of POC Luna inox available: over-(G) and under-the-sink(D).
The water heaters are also available with a tap provided by manufacturer. They will operate as a non-pressure
appliance; symbols: POC.Gb-5/2 oraz POC.Db-5/2.
POC.Gb-5/2, POC.Db-5/2
tap
set works as an air vent and
therefore, cannot be connected
to any valve or a connector that
is not recommended by the
manufacturer.
Purpose
Safety and faultless
work conditions
- in order to make use of the appliance it must be properly installed,
- you must not put the heater on if it is not full with water
- the appliance should be vented (see 'Venting') before the activation and each time after a decay of water,
- do not open the heater casing while power is on,
- the appliance can be connected only to a plug-in socket with a safety pin,
- an extension cord must not be used to connect the heater with a socket,
- water at 40
0
C temp. may bring forth the feeling of burning (especially with children); remember that the fit-
tings (e.g. a tap, pipes) also reach high temperature while working,
- while assembling the POC.G-5/2 or POC.D-5/2 water heater, a safety valve has to be fitted right before the
appliance on water mains supply pipe; if the water pressure is higher than 0,6 MPa, a pressure reductor has
to be fitted on the water mains supply pipe before the safety valve,
- the outlet must not be clogged while water is on and no other appliance should be adjusted to it,
