ENG-003B
3
You must not install this
appliance in places exposed
to the danger of explosion and
places in which the temperature
may go down below 0°C.
The EPJ.P Instantaneous Water Heater provides hot under the shower. It can be installed either over a bath or
inside a shower cabin. Turning the hot water tap on, automatically starts up the heater (a red light on the heater's
outer case comes on). Water is heated instantly as a result. The temperature of heated water depends on the rate
of flow: the greater the flow, the lower the temperature. Turning the hot water off, shuts the appliance.
The heater features:
- tubular heating coils that assure maximum safety
- materials resistant to corrosion and chemically inactive with water (copper, brass, stainless steel, plastic)
This appliance will work with
the attached tap set only.
The tap set works as an air vent
and therefore, cannot be con-
nected to any valve or a connec-
tor that is not recommended by
the manufacturer.
You must not install in direct
vicinity of the range of spray of
the spray-head.
Description
Technical data
EPJ.P water heater
4,4
5,5
Rated power
kW
4,4
5,5
Rated voltage
230 V~
Rated current
A
19,1
23,9
Minimum pressure
MPa
0,12
Protection degree
IP 25
Operating pointa
l/min
1,8
2,2
Efficiency (Δt=30°C)
l/min
1,9
2,4
Dimensions (without the mixer)
mm
214 x 218 x 95
Weight ( mixer)
kg
2,2 + 0,6
Fuse rated current
A
20
25
Min section of supply conductors
mm
2
3 x 2,5
Water connections
G 1/2"
Summary of Contents for EPJ.P-4
Page 1: ......
Page 11: ...11 ENG 003B Installation and operation instruction EPJ P ...
Page 12: ......
