KORTHO Hot Quick Coder Manual
11
4 - INSTALLATION OF THE HOT QUICK CODER
4.1
Assembly instructions
During assembly ensure that sufficient space is left around the coder to replace the Ink Roll and to change the type holder.
If necessary, set up the coder so that it revolves. The dimensional sketches are included in Appendix D.
1.
Mark the desired position of the holes for assembling the support (2.75” C-C). When determining the position, take
account of the fact that the type holder (in the marked position) should ultimately be located approx. 5/64” - 1/8” from
the product surface to be printed (figure 7b).
2.
Drill the mounting holes for the support (diameter 17/64”).
3.
Assemble the support with 1/4” bolts (x2).
4.
Fix the coder to the support.
5.
Mark the desired position of the holes for assembling the Control box.
6.
Drill the mounting holes for the Control box (3/16” diameter).
7.
Assemble the Control box with #8 Screws and nuts (x4).
Options for coding products
Options for coding lengths of film
4.2
Connection instructions
1.
Disconnect the printer from the voltage by removing the main power cable from the Control Box.
2.
Open the Control box.
3.
Check that the desired power supply is set correctly. (see appendix C).
4.
Connect a sensor to supply the print command. The connection points and settings of the switch and jumpers are
given in appendix C.
5.
Connect the power and control cable to the coding part.
6.
Connect the Control box to the compressed air supply (setting approx. 58 psi) via the reducing valve.
7
.
Connect the HQC to a
grounded
connection.
! WARNINGS:
Before opening the control of the Hot Quick Coder, it should first be disconnected from the power. This is done by removing
the main power cable from the Control box.
Only a GROUNDED cable may be used for connecting the equipment
