9
Krisis KARRE - User’s manual
Outer containers and front containers as well as harnesses with integrated container compartment
are equipped with a release handle, which must be connected to the inner container of the reserve.
The use of original release handles is mandatory.
Release handles with possibility of looping in the original inner container
If there is a possibility of looping in the deployment handle, it is recommended to attach the
KORTEL DESIGN
inner container to it. It is then very important to check the length between the
handle and the inner container.
The shorter the connection from the release handle to the inner container is, the easier it is to pull
out and throw the reserve. However, the connection must be at least long enough to ensure that
the locking pins are released when the handle is pulled. To prevent an entanglement of the release
handle in the suspension lines while they are stretching, the maximum length of the connection
from the release handle to the inner container must not exceed 37 cm.
There are three loop-in options on the
KORTEL DESIGN
standard flat container:
• The attachment to the triangular pull tab is preferable, as it is the best prevention against the
container getting stuck during the extraction from the harness.
• The attachment point on the side is intended for harnesses with a rear container compartment.
• The bottom attachment point is used when the 37 cm would be exceeded when using the
triangular pull tab. How to measure the length of the connection is shown in the pictures.
Connecting the inner container to the release handle
