10
Krisis KARRE - User’s manual
The following steps describe the repacking of a
KRISIS KARRE
from the
KORTEL DESIGN
standard
flat container into the GIN Genie Lite 3 cloverleaf inner container.
It is not a problem that third-party containers usually have only one closure for the two line bundles.
The bundles can simply be put together in the closure rubber.
Repacking into third-party inner containers
Please contact the harness manufacturer if the release handle connection is too long. If it is
necessary to shorten the connection between the handle and the inner container, this must be done
by the handle manufacturer or another qualified specialist. It is required to use a high-strength
sewing thread for this purpose.
Release handles and third-party inner containers
In modern harnesses with integrated container compartment, the release handle and inner
container usually are a single unit, which has been specially tested during the approval of the
harness or front container. The
KORTEL DESIGN
pocket container can no longer be used for these
harnesses. Rather, it is necessary that the reserve is repacked into the harness manufacturer’s inner
container.
KORTEL DESIGN
permits this, provided that it is a standard cloverleaf inner container and
its volume is not less than that of the
KORTEL DESIGN
rescue system (see technical data). If the
design of the third-party inner container differs significantly from the usual cloverleaf containers,
the handle-inner container combination must be sent to
KORTEL DESIGN
for approval.
Please note
: The following steps for repacking the reserve into a third-party
cloverleaf inner container are to be understood as an example only. Detailed
instructions must be obtained from the respective manufacturer of the thirdparty
container.
Unpacking from the
KORTEL DESIGN
standard flat container
Reserve packed inside the
KORTEL
DESIGN
standard flat container
Tie both line bundles together with
packing cords
