3
1.PRECAUTIONS
1-1 SAFETY PRECAUTIONS
WARNINGS : Service should not be attempted by anyone unfamiliar with the necessary
precautions on this monitor. The following precautions are necessary during
servicing.
1) For continued safety, do not attempt to modify the circuit board.
2) Disconnect the AC Power before servicing.
3) When the Monitor is operating, do not touch any heatsink on the Chassis as it is self-heated.
1-1-1 FIRE & SHOCK HARZARD
1) During servicing, pay attention to the original wires whether it is uncoated or undressed,
especially the wires in the high voltage circuit section. If there is any uncoated or melted
wire is found, then please do not try to replace the related parts, and wait for the qualified
service person's coming.
2) Many electrical, mechanical parts in this monitor have special safety-related characteristics for
protection against shock hazard and others. These characteristics are often passed unnoticed
by a visual inspection and the protection afforded by them cannot necessarily be obtained
by using replacement components rated for higher voltage wattage,etc.
Replacement parts which have these special characteristics are identified in the manual and
supplements by shading on the schematic diagram and the parts list.
3) When replacing Chassis, always be certain that all the protective devices are installed
properly.
4) leakage current check (figure 1)
KORTEK Corporation
KT-XX03NA
