Please check the CPU pin or knob around the target A/D or the A/D to change is detected.
About correspondence to be tested A/D display, please refer to the above table.
A/D a change is detected is indicated 7-segment display in the "20 **".
Correspondence between the A/D of "**" see table below.
"**" Is a bit pattern."
bit pattern knob name
CPU pin No. knob name
CPU pin No.
_______*
PITCH 3
91
LFO RATE
99
______*_
PITCH 2
92
OCTABE
100
_____*__
PITCH 1
93
BATTERY
1
____*___
LFO INT
94
SYNC CN
2
___*____
CUTOFF EG INT
95
__*_____
DECAY/RELEASE
96
_*______
ATTACK
97
*_______
TEMPO
98
Synchronization function inspection error table.
(Inspection Number[4,*])
If the error occurs in this test, please check A / D and the corresponding SYNC IN terminal and SYNC
OUT terminal, and, (2, 85, 86, 87 CPU PIN) interrupt.
Error number table is shown below.
7segment
Display[100#]
error contents
7segment Display [20##]
1001
Connecting to SyncIn terminal is
detected at the time of entering
the test
1002
Change of A / D except terminal
of SyncIn is detected.
Interference A/D number. Please refer to the table
number A/D of (knob) inspection.
1003
An error has occurred in the loop
test for the first time.
1004
An error has occurred in the loop
test for the second time.
The meaning of each digit in the binary representation
(Bit0) Rise undetected during Rise inspection
(Bit1) Fall undetected during Fall inspection.
(Bit2) Rise detected during Fall inspection.
(Bit3) Fall detected during Rise inspection.
Error Display a list of power-off test
(inspection number [15.#]
(note) (*)After pressing the button, if the LED flashes
It can not complete the power-off operation.
Please check power switch, control pin (CPU PIN 22) etc..
