Korg LED slider, Installation Manual

Page: 6 / 17

Figure 4 - Slider Assemblies Wired Into PCBs (All sliders aligned. ARP OMNI 2 shown)
5) When the assemblies have been wired to the PCBs, you can connect
each PCB to the LED power supply using the mating connectors. This
allows for brightness adjustment of each LED. Note that the LFO RATE
slider won’t be lit. This LED will only light if the LFO on the ARP is running.
In this case, we will only be running the LED circuit on the sliders. This
step can be done after you have wired the 5V LED supply into place.
Using a preferably non conductive jewelers screw driver, adjust the LED
brightness for each slider. If using custom colors, be sure to cut the legs
of the enclosed LEDs to the same length as the legs of the LEDs that
came mounted in the sliders. If the LED is put into the slider backwards,
that LED will not light. Reverse LED polarity if this happens.