Korg LED slider, Installation Manual

Page: 5 / 17

Figure 3 - Sliders Assembly Tack Soldered (Each slider soldered in place by only one pin)
Now that the slider asseblies are held in place, heat up the tack
solder joint holding each slider into place and adjust so that slider
shafts are perpendicular to the pcb and the slider PCB is parallel with
the ARP PCB. Notice that the sliders can easily be moved into align-
ment by gently moiving them or heating up the tack solder joint.
Don’t hold the soldering iron tip to the tack solder joint for more than
2-4 seconds. Too much heat can cause the slider adapter PCB pins to
become unsoldered.
You can now test fit the PCB to the chassis. When you have fit the
PCB back into the chassis of the synth, screw the PCB into place. Ad-
just any sliders that arent straight, then solder each sliders remaining
pins int the PCB. When the PCBs are screwed into the chassis, you
can gently hold the slider into the desired position and solder the
remaining legs.