6
4. Function "NEXT SONG"
This function can be used to chain together several songs of the same partition in any order and play
them back one after another without a break.
NOTE: When you create a song chain, the command "Go to song XY" is added to the end of each
song (except for the last one).
If you want to play back a single song out of a song chain, you must press the STOP key at the end of
desired song. Otherwise the next song will be started.
Example: Song A and Song B will be played back in a song chain.
a)
Use the numerical song selection method to check the number to which Song A is assigned.
b)
DISK mode, page 1: select LOAD ALL SONG.
c)
Press cursor position key B.
d)
Use the VALUE dial or the DOWN/UP keys to select the song that will be used as Song A.
e)
Use cursor position keys H and E to load Song A.
f)
After you have pressed the SONG and PAGE+ keys, select page 11: UTILITY of the Song menu.
g)
Enter the number of Song B into submenu "NEXT SONG" and use the VALUE dial or the
DOWN/UP keys to enable the AUTO START function above cursor position key H.
h)
Use the "DELETE SONG" function on page 5: UTILITY of DISK mode to delete Song A from the
hard disk.
i)
Select page 3: SAVE of DISK mode and save Song A to hard disk.
After Song A has been played back to the end, Song B will start automatically. To chain Song C to the
end of Song B, repeat steps a) to i) accordingly. The same goes for Songs D, E, F, etc. until all 112
songs of a partition have been chained together.
5. Function "FORMAT"
If you want to format a Hard Disk you have to press the "EDIT STYLE" and the "EDIT PROGRAM"
keys and while you press these keys switch the I2/I3 on.
x
Select the DISK mode and go with the buttom PAGE+ to the page DISK 5: UTILITY. Now go with
the cursor to function FORMAT DISK and select it. Select with either the UP/DOWN keys or with
the value dial the according partition. Press the cursor position keys G or H to format the partition
and confirm it with cursor position keys E or F.
x
If the formatted partition contains Data Files the message appears: DISK: CONTAINS XY FILES
on the display. Check the data on these Hard Disk partition and deside if you want erase all data
wtith format or not.
x
If the message appears: HARDDISK: ERROR switch the keybord off immediadely and check the
installation of the Hard Disk drive kit. These message is a sign that the operating system doesen´t
regognize the Hard Disk and is operating not well.
NOTE: We are not liable for any loss of data caused by faulty hardware!
