Wiring the Digital Input (DI)
The Digital Input (D.I.) contacts are in the bottom side of the device as shown in Figure-4.
,WDFFHSWVRQHH[WHUQDO'&W\SHVLJQDOLQSXWDQGFDQEHFRQ¿JXUHGWRVHQGDOHUWPHVVDJH
through Ethernet when the signal is changed.
Note:
the DI accepts DC type signal and supports isolated input circuit with Digital High
Level input DC 11V~30V and Digital Low Level input DC 0V~10V. Don’t apply higher
YROWDJHWKDQWKHVSHFL¿FDWLRQLWPD\FDXVHLQWHUQDOFLUFXLWGDPDJHRUDZURQJDFWLRQRI',
Connecting to Network
1. Connecting the Ethernet Port:
Connect the Ethernet port of JetNet 6059G with the
other Ethernet device by Cat-5/Cat-6 UTP or STP cable, and then the LNK/ACT LED will
WXUQRQDQGVWDUWÀDVKLQJWRLQGLFDWHWKHFRPPXQLFDWLRQLVRFFXUUHGEHWZHHQGHYLFHV
2. Connecting the SFP Port:
3OXJLQ6)3¿EHUWUDQVFHLYHU:HUHFRPPHQGXVLQJ.RUHQL[
FHUWL¿FDWHG6)3PLQL*%,&WUDQVFHLYHU&URVVFRQQHFWWKHWUDQVPLWFKDQQHODWHDFKHQGWR
the receive channel at the opposite end as illustrated in the Figure-5.
Figure-5
Ǽ
This is a Class 1 Laser/LED product.
Don’t looke into the Laser/LED Beam.
TX
RX
A
B
TX
RX
ATTENTION
Figure-4