11
3. After the DIN-Rail bracket is screwed on the rear side of the switch, insert the top of
the bracket into the rail. Then, lightly pull-down the bracket into the rail. Be sure the
DIN rail specification is compliance EN 50022 standard. (3.5cm DIN rail )
Figure-11
4. Check if the bracket is tightened on the rail or not.
5. To remove the switch from the rail, reverse steps above.
Wall Mounting
Please refer to
Figure-12
and follow the steps below to mount the industrial switch with
wall-mount bracket, and the detail dimension of the bracket as
Figure-13
.
1. Remove the DIN-Rail bracket from the switch; loose the screws to remove it.
2. Place the wall-mount bracket on the top side and bottom side of the switch.
3. Use the screws to screw the wall-mount bracket on the switch.
4. Use the hook holes at the corners of the wall-mount bracket to hang the industrial
switch on the wall.
5. To remove the wall-mount bracket, reverse steps above.
