17
address 192.168.1.1 as an example.
11. Repeat step 10 to make sure that the connection of each device
connected to the JetNet3008 is successfully established.
12. Power on the PC host, activate the Command Line mode, and ping the
connected Ethernet device by typing “ping 192.168.1.1 –t” command
to see if it will respond. Do remember the PC host IP address is same
subnet address as target device – 192.168.1.1.
13. The parameter-”t” allow you to continue to ping the network device, as
shown in the figure below.
Before you continue, make sure that both PWR1 and PWR2 are
Summary of Contents for JetNet 3008 v3
Page 24: ...21 ...
