10
4-1. Wiring the DC Power Inputs
Follow the steps below to wire JetNet 3008’s / JetNet 3008f’s dual DC
power inputs.
[Note] The suitable electric wire ranges is from 12 to 24 AWG.
Equipment intended for installation in a Restricted Access Location.
Before install power, be sure the power supply module is compliance with
UL certificated LPS power and the power system is shut down to avoid
any damage. About the wiring please refer following diagram.
V- V+
V- V+
1. Insert the positive and negative wires into the V+ and V-
contacts respectively of the terminal block connector
2. Tighten the wire-clamp screws to prevent the DC wires
from being loosened.
Summary of Contents for JetNet 3008 v3
Page 24: ...21 ...
