12. Repeat step 10 to make sure that the connection of each device linked
to the JetNet switch is successfully established.
13. Power on the PC host, activate the Command Line mode, and ping the
connected Ethernet device by typing “ping 192.168.1.1 –t” command
to see if it will respond. Remember that the PC host IP address is the
same subnet address as that of target device – 192.168.1.1.
14. The parameter-”t” allows you to continue to ping the network device,
as shown in the figure below.
Before you continue, make sure that both PWR1 and PWR2 are
successfully connected to power sources. When PWR1 fails, the LED for
17
