3. DIN Rail Mounting
The DIN Rail clip is screwed on the rear panel of the device which
supports EN 50022 type rail installation. The following diagram includes
EN50022 rail dimensions for your reference.
The DIN rail should be behind
the spring when installing the
JetNet device onto the
standard DIN Rail.
Follow the steps below to mount
the JetNet 3006 /JetNet 3006f
on the DIN-Rail track.
1. Insert the upper end of the
DIN-Rail clip into the back of
the DIN-Rail track from its
upper side
2. Lightly push the bottom of the
DIN-Rail clip into the track.
3. Check if the DIN-Rail clip is
tightly attached to the rack.
4. To remove the JetNet 3006 /
3006f from the track, reverse
the steps above.
12
