16
11. Power on the host, activate the Command Line mode, and ping the connected
Ethernet device by typing “ping –t 192.168.1.1” command to see if it will
respond.
12. The parameter-
”t” allow you to continue to ping the network device, as shown
in the figure below.
Before you continue, make sure that both PWR1 and PWR2 are successfully
connected to power sources. When PWR1 fails, the LED for PWR1 will go out. At
that moment, if the ping command is still replying, then it proves that redundant
power input function works normally.
13. Exit the Command Line mode, and connect PWR1 power input. At this stage,
your JetCon 1701GP-U has been tested and the installation is completed.
