Kopp Radio motion sensor, Instruction Manual

Page: 7 / 29

6
Please read the operating instructions carefully!
Dependable early warning and protection against
burglary is only ensured if this radio motion sensor
(mobile) is used in accordance with the following
instructions.
The radio motion sensor (mobile) can be combined
with all Free-control radio receivers, radio alarm
stations, and radio burglary alarm centers.
Mounting - setup
Select a suitable mounting or setup location
Do not point the lens toward heat sources, such as
radiators, ovens, etc.
This may lead to false alarms.
The orientation of the device should not be able to
be changed by vibrations or unintentional contact.
If possible, mount the radio motion sensor (mobile)
so that it is not immediately recognizable.
Before final mounting, please check to ensure that
the intended receiver reliably receives the radio
signal of the motion sensor.
If necessary, change the position of the receiver or
the motion sensor.
Use wall bracket

for wall mounting.
Drilling guide on fold-out side.
Set operating scenario
The radio motion sensor (mobile) can be used for
two different applications.
Operating scenario 1:
• Signal evaluation by the radio alarm station
• Switching of radio receivers
- Flush-mounted receiver 1-channel 2-wire and
3-wire
- Flush-mounted receiver 2-channel or blinds
- Flush-mounted receiver buttons or time function
- Flush-mounted receiver dimmer function for
electronic transformers (switch on/off function)
- Flush-mounted receiver dimmer function for
- conventional transformers (switch on/off function)
- Lamp socket
- Adapter switch function
- Adapter dimmer function (switch on/off function)
- Grounding-type multiple socket outlet
Set operating scenario 1:
For this, set the encoding switch

in the battery
compartment as follows:
Slide 1 = OFF
Slide 2 = OFF
Twilight threshold:
Device is always active regardless of the ambient
brightness!
An ON-switching command is transmitted if move-
ment is detected.
An OFF-switching command is transmitted one minu-
te later (fixed setting).
The device is ready for operation approx. 60 sec
after a battery replacement.
The yellow LED

illuminates during this settling
phase.
