12
USE – PLACING THE WATER TANK
Make sure the water tank is placed correctly.
Fig. 2
Place the water thank.
USE – DRY IRONING
1. Insert the plug (13) into the wall socket.
2. Turn on the main on/off switch (11) by switching if to position 1. The pilot light turns on.
3. Turn the iron temperature control dial (2) to the desired position (see the table in “Ironing instructions” ) . The
pilot light (9) turns on.
4. Place the iron in a vertical position (upright) and wait until the pilot light (9) goes out. The iron is now ready to
iron. Iron the fabric by sliding the iron over the fabric. While you are ironing, the heating element will automati-
cally switch on and off to keep the soleplate at the set temperature. The pilot light (9) will, therefore, also turn on
and off automatically.
5. After use, rotate the iron temperature control to the 0 position, turn off the main on/ off switch by switching
it to position 0. Remove the plug from the wall socket. Place the iron in a vertical position and allow it to cool
down.
USE – STEAM IRONING
1. Fill the water tank (see “Filling the water reservoir”) .
2. Insert the plug (13) into the wall socket.
3. Turn on the main on/off switch (11) and turn the temperature control knob (2) beyond the steam symbol.
ONLY IN THIS WAY THE SOLEPLATE WILL REACH THE TEMPERATURE NEEDED TO STEAM IRON
AVOIDING WATER LEAKEGE.
4. When both pilot light go out you can start steam ironing.
5. When the steam pilot light turns on, you must wait until the boiler has built up sufficient steam pressure
again.
6. The steam spray of this product can only be smooth after pressing the steam iron button for several times.
7. Leave the device steaming (for ca. 20 sec) before every use by pushing the steam release button (3) to remo-
ve calcium deposits.
8. After use, rotate the iron temperature control to the 0 position, turn off the main on/ off switch by switching
it to position 0. Remove the plug from the wall socket. Place the iron in a vertical position and allow it to cool
down.
If the temperature is too low, drops of water can escape with the steam causing stains. If this does happen,
you should turn the temperature control dial to the recommended position. Never iron whilst there are drops of
water on the soleplate.
