2
to figure out damages, if any. In case of any damage detected, please contact us through phone or fax
immediately, and we will respond to the situation as soon as possible.
4.3 In case of any damage or loss, please identify the situation in the packing list and have the
consigner acknowledge it with signature before returning it to us.
5
、
Installation
5.1 The product should be place on a solid and flat floor with no gradient.
5.2 The product is recommended to work with under 28
℃
ambient temperature and less than 55%
relative humidity, where direct sunshine and draught can be avoided. Additionally, disturbing air
devices such as fan or air conditioner vent should be appear from its top or nearby.
5.3 Unobstructed ventilation should be ensured for condensing unit with ample room for
repairing.
5.4 The melting water can be directed into the sewer near the product, if any, or otherwise
evaporated through electric heating.
6
、
Normal operation
6.1 Full-automation. Fully consider the local seasonal conditions within a year and the surrounding
environment are sufficiently considered during the setting of control modules, to ensure the optimal
operation of the whole full-automatic product.
6.2 Normal cooling. Set the temperature controller properly according to customers’ needs to
achieve both energy-saving and normal cooling. See the Appendix: Instruction of CAREL Temperature
Controller for details.
6.3 Normal melting. Set the timer properly for melting time and interval according to the ambient
temperature and humidity, with over two melting periods for verification. See the Appendix:
Instruction of CAREL Temperature Controller for details.
6.4 Have the customer sign Debugging Record and Installation Acceptance Report before finishing
the consignment.
6.5 During normal operation, the storage should not be placed beyond the shelf or block the
return air from the air curtain.
7
、
Maintenance and notes
7.1 Cabinet cleaning. The product should be cleaned once a week with power supply disconnected.
In cleaning, please use mild rinsing water or non-corrosive cleanser essence. Do not wash it directly
with water faucet.
7.2 De-dusting for condenser. The condenser should be cleaned every three months with power
supply disconnected. To clean the condenser, remove the left panel, and remove the dust on the
cooling fin of the condenser with wire brush or high pressure air gun.
7.3 Leaking check. Observe all connectors and welding joints for oil stain, which indicates a must
for patching measures or call for professionals.
