Page 1
3
FAULT-FINDING
If the CLIMATEASY 1
4
is not operating, proceed as follows:
Check that the mains plug is firmly in the socket, and that the
socket is switched ON.
When the unit if switched on there will be a delay of about 1
minute before it starts to operate.
Unit stops running:
Mains supply is disconnected or has failed
Target temperature has been reached.
Timer has been set.
Water tank is full (WATERFULL indicator will illuminate)
In cooling mode, no cool air is produced:
Room temperature is lower than set temperature
The unit is defrosting (this will take a few minutes, and
afterwards, it will resume operation)
Filter is blocked
Cooling is poor on hot days
Too much direct sunshine is heating the room
Windows or doors are open allowing hot air into the room
A lot of people in the room (each person contributes about
75W of heating)
Electrical equipment in the room producing heat
Heating is poor on cold days
The heat pump can only heat effectively when the outdoor
temperature is above 7 °C. The unit is not intended as a
primary means of heating premises.
Remote control does not work:
Check batteries are correctly installed, and are not exhausted.
Make sure that the remote control is pointed towards the main
unit when being used.
