Page
7
OPERATION
Leave the appliance in an upright position for 3 hours before
first use.
Plug the mains lead into a 13 Amp mains socket (unless
permanently installed)
If connecting via an extension lead, make sure that the lead is
rated at 13 Amps or more, and that it is fully unwound. Switch
the unit on at the mains socket.
ON/OFF Button:
Press the "ON/OFF" button to start the unit.
The Power indicator illuminates when the appliance is ON.
There will be a short delay
(up to 3.5 minutes
) before the
appliance starts to operate.
"MODE" Button:
Select the mode by pressing the "MODE"
button. The available modes are:
Cooling mode:
cools if the room temperature is above the
selected temperature. Then use the
TEMP+
and
TEMP-
buttons to select the desired room temperature. When the
temperature reaches the desired temperature, the compressor
will stop, and the fan will continue to run.
Dehumidifying mode:
removes humidity, but does not effect
room temperature. The fan operates at its lowest speed. For
best results, do not use the exhaust tube, but fit a permanent
drainage pipe to the drain outlet as shown on page 9.
Fan mode:
circulates the air, but does not affect room
temperature or humidity.
NOTE: If you change the fan speed, the speed will increase or
decrease as requested but there will be no discernable change
evident because of the type of fan fitted.
Heating mode:
heats if the room temperature is
below the selected temperature. Then use the
TEMP+
and
TEMP-
buttons to select the desired room temperature.
