OPERATING INSTRUCTIONS
You can adjust the temperature to match the variety of wine by adjusting the temperature
control knob located inside on the top right corner. “High” is the warmest setting and “Low”
is the coldest setting. The dial may be set any place on the scale, it does not have to be set
exactly on a number.
It will take approximately 1 hour for the unit to stabilize the temperature. Fill the wine cooler
with your choice of wine bottles. Allow 2 hours of operation before the bottles reach the
desired temperature.
The Wine Cellar should be placed where the ambient temperature is between 59°F to 77°F
(15°C to 25°C). If the ambient temperature is above or below this range, the performance of
the unit may be affected. For example, placing your unit in extreme cold or hot conditions
may cause interior temperatures to fluctuate.
RECOMMENDED TEMPERATURES FOR CHILLING WINE
Red Wines: 59-66°F (15-18°C)
White Wines 46-59°F (8-15°C)
The above temperatures may fluctuate depending on whether the interior light is ON or OFF
or the bottles are located on the upper/middle/lower section.
Temperature
Control Knob
LED Light
Light Switch
INSTALLATION
BEFORE USING YOUR WINE CELLAR
• Remove the exterior and interior packing.
• Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION OF YOUR WINE CELLAR
• This appliance is designed for free standing installation. Allow 50 mm of space between
the unit's side and 100 mm between back and the wall.
• Place your Wine Cellar on a floor that is strong enough to support it when it is fully loaded.
To level your Wine Cellar, adjust the front leveling leg at the bottom of the Wine Cellar.
• Locate the Wine Cellar away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the unit not to
perform properly.
• Avoid locating the unit in moist areas.
• Plug the Wine Cellar into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning about power and/or grounding should be directed toward a certified
electrician or an authorized products service center.
4
100mm
4 in
50mm
2 in
50mm
2 in
5
