FORK TIP ADJUSTMENT
S
K
NOTE:
(FIG.11 & 12)
The fork tip adjustment is preset from factory. However, if you notice the front wheel
is not tracking correctly in position, you may need to adjust the front wheel for correct
alignment. To adjust the front wheel alignment in linear position, loosen the screw
on
the fork tip , and manually move the wheel to the desired position. You may need to roll
the stroller back and forth to test the new setting. Tighten the adjustment screws
when wheel is aligned.
To achieve proper wheel alignment, you may need
to test roll the stroller several times.
ADJUSTING THE REAR Q/R AXLE
L
P
Q
J
Q
TEST FIT THE WHEEL
P
!
Now and then it is necessary to adjust the axle so
that it clamps down correctly. Simply hold the
small nyloc nut with a 8mm wrench (provided)
or a pair of needle nose pliers and turn the cam
lever
on the opposite end of the skewer until
the swedge cap and the shank begin to spread the
split ring . Be sure to have the cam lever
in the
closed position while turning it. (This will be the
position it is shown in FIG. 10 ).
1) Insert the wheel axle and wheel assembly into the
hole on the axle end with the cam lever open.
1a) Close the cam lever (you should feel some resistance) then pull on the wheel with a fair
amount of pressure (pull it hard) . If the wheel does not pull out then you are done.
1b) If the wheel pulls out even a little, you need to further adjust the tension of the
skewer. To do this, remove the wheel and proceed as fallows:
Hold the Nyloc nut with the pliers or socket wrench .
Turn the cam lever clockwise 1/2 to 1 turn.
Retry the "fit of the wheel process" .
!
!
!
J
