5
1. In General ......................................................................................................................................... 5
2. Connection to KONTRONIK speed control ................................................................................... 5
3. Mounting of this motor ................................................................................................................... 5
4. Maintenance ..................................................................................................................................... 5
6. Warranty ........................................................................................................................................... 6
7. Service / Recycling .......................................................................................................................... 6
8. Technical Support / Hotline ............................................................................................................ 6
9. EG conformity declaration ............................................................................................................. 6
English Instructions
1. In General
The PYRO motors are specially designed for use in
helicopter.
-
Neodym magnets up to 150°C heat resistant
-
Special copperwire up to 300°C
-
Fine balanced
-
Optimized sheet metal cut
-
Optimized air circulation
-
Radial fan
-
Optimized magnetcircle
The KONTRONIK motors are brushless motors, i.e.
they require a commutation in the speed control. The
following
KONTRONIK
speed
controls
are
recommended:
PYRO 700-x
Jive 80+ HV; Powerjive
120+ HV
A use of these motors with traditional speed
controls (for brushed motors) or by direct
connection to a power supply is not admissible.
Such a use can damage the motor.
The technical data and the maximum continuous
power input are shown in chapter 10 to 12.
2. Connection to KONTRONIK speed control
-
Connect the motor cable with the speed control. The
motor rotation will be reversed by changing 2 of the 3
motor cables and/or by mode 7 of Jive- speed controls.
3. Mounting of this motor
While fixing the motor on the front flange, the
permissible screwing depth is to be considered.
Motor Type
Screw
Pitch Circle
Max. thread
reach
PYRO 700-
x
M4
30mm
8mm
Additionally, KONTRONIK strongly recommends the
installation of a counter bearing for extreme applications
such as hard 3D flight.
4. Maintenance
Brushless motors need no maintenance. It’s not
necessary to open the motor because it works
maintenance free. It’s enough to keep the motor clean
from dirt and water.
The motor cables are of non solderable enamelled
copper wire.
It is not allowed to shorten these cables.
