SmartClient-KLU - User Guide, Rev. 1.2
// 20
4.2.4.
DP
The SmartClient-KLU provides one DP connector. One external (digital) display can be connected to this DP connector.
4.2.5.
Line-In
The Line-in jack is designed to take input from a higher-powered sound source.
4.2.6.
Line-Out
The stereo headphone jack is used to connect the system’s audio out signal to amplified speakers or headphones.
4.2.7.
Mic-In
The microphone jack is designed to connect the microphone used for video conferencing, voice narrations, or simple
audio recordings.
4.2.8.
GbE
These connectors are Gigabit Ethernet 10/100/1000 Mbit/s, IEEE 1588 capable interfaces. The connectors are
standard 8-pin RJ45 type connectors with status LEDs:
Figure 2: Ethernet LED Status
4.2.9.
USB 3.0
The SmartClient-KLU provides four USB 3.0 / 2.0 interface. These connectors allow connection of USB 3.0 or USB 2.0
compatible device to the system.
4.2.10.
RS232/422/485
COM 1 and COM 2 are provided as a 9-pin D-SUB connector and allow the connection of a serial peripheral. They are
designed to support RS232/422/485 serial communication which can be configured via BIOS setup.
LED satatus:
Orange - 1000 Mbit/s link established
Green - 100 Mbit/s link established
Off - 10 Mbit/s link established
LED satatus:
Off - Link is down
Flashing Green - Link is up and active
Steady Green - Link is up, no activity
