Kontron PCI-COM422, User Manual

Page: 20 / 36

page 20 PCI-COM422 User’s Guide
Software Installation
The software provided with this board is contained on a CD and must be installed onto
your hard disk prior to use. To do this, perform the following steps as appropriate for
your software format and operating system. Substitute the appropriate drive letter for
your CD-ROM where you see
G
: in the examples below.
CD Installation
DOS
1. Place the CD into your CD-ROM drive.
2. Type
Gx
to change the active drive to the CD-ROM drive.
3. Type
LQVWDOOx
to run the install program.
4. Follow the on-screen prompts to install the software for this card.
WINDOWS
1. Place the CD into your CD-ROM drive.
2. The CD should automatically run the install program. If the install program does
not run promptly, click START | RUN and type
GLQVWDOO
,
click OK or
press
x
.
3. Follow the on-screen prompts to install the software for this card.
LINUX
1. Please refer to linux.htm on the CD-ROM for information on installing under linux.
Configure Card Options via Jumper Selection
Before installing the card into your computer, carefully read Option Selection section of
this manual, then configure the card according to your requirements and protocol (RS-
232, RS-422, RS-485, 4-wire 485, etc.). Our Windows based setup program can be
used in conjunction with the Option Selection section to assist in configuring jumpers on
the card, as well as provide additional descriptions for usage of the various card options
(such as termination, bias, baud rate range, RS-232, RS-422, RS-485, etc.).