NSC2U Server—Optional Component Installations
Kontron IP Network Server NSC2U
Product Guide, rev. 1.4
December 2009
50
4
Optional Component Installations
4.1
Before You Begin
Before working with your server product, pay close attention to the safety instructions
Appendix A, “Safety Information”
Warning:
Electrostatic discharge (ESD) and ESD protection: ESD can damage disk drives,
boards, and other parts. We recommend that you perform all procedures in this chapter
only at an ESD workstation. If one is not available, provide some ESD protection by
wearing an antistatic wrist strap attached to chassis ground (any unpainted metal
surface) on your server when handling parts.
4.1.1
Tools and Supplies Needed
• #1 and #2 Phillips (cross-point) screwdrivers, or interchangeable-tip screwdriver
with #1 and #2 Phillips bits
• Personal grounding device such as an anti-static wrist strap and a grounded
conductive pad
4.1.2
System References
All references to left, right, front, top, and bottom assume that you are facing the front
of the server, as it would be positioned for normal operation.
4.1.3
Cable Routing Reference
It is important for cables to be connected correctly. See
and for more detailed
information about cable connectors, see the
Kontron IP Network Server NSC2U
Technical Product Specification.
