MSP8040 Series User Guide Rev. 1.2
www.kontron.com
// 31
Sensor
Name
Event/Reading
type code
Sensor Type
Sensor Specific
offset
Event Trigger
Board
Reset
03h
Standard IPMI
Discrete
CFh
OEM
Kontron
Reset
00h
01h
State Asserted /
State Deasserted
Event Data 2: Reset Type
00h: Warm reset
01h: Cold reset
02h: Forced Cold [ Warm reset reverted to Cold ]
03h: Soft reset [ Software jump ]
04h: Hard Reset
05h: Forced Hard [ Warm reset reverted to Hard ]
Event Data 3: Reset Source
00h: IPMI Watchdog [ cold, warm or forced cold ]
( IPMI Watchdog2 sensors gives additionnal details )
01h: IPMI commands [ cold, warm or forced cold ]
( chassis control, fru control )
02h: Processor internal checkstop
03h: Processor internal reset request
04h: Reset button [ warm or forced cold ]
05h: Power up [ cold ]
06h: Legacy Initial Watchdog / Warm Reset Loop Detection *
[ cold reset ]
07h: Legacy Programmable Watchdog [ cold, warm or forced
cold ]
08h: Software Initiated [ soft, cold, warm of forced cold ]
09h: Setup Reset [ Software Initiated Cold ]
0Ah: Power Cycle / Full Reset / Global Platform Reset
FFh: Unknown
Health
Status
7Fh
OEM Health
Severity Status
Sensor
24h
(Platform
Alert)
00h Status not
available in
current state
01h Healthy
02h
Informational
fault
03h Minor fault
04h Major fault
05h Critical fault
Event Data 3:
If the sensor is an aggregation sensor, then event data 2 is
used to return the ID of the first sensor from the aggregation
that caused the fault.
Sensor Aggregation List:
ID - Sensor Name
01h - Temp Inlet
02h - Temp Vcore
03h - Temp M2
04h - Temp BMC
05h - Temp CPU
06h - Temp DIMM A
07h - Temp DIMM B
08h - Temp DIMM C
09h - Temp DIMM D
0Ah - Temp PCIe Slot
0Bh - Vcc +12V IN
0Ch - Vcc +5V SUS
0Dh - Vcc +3.3V SUS
0Eh - Vcc +1.7V SUS
0Fh - Vcc +1.5V SUS
10h - Vcc +1.3V SUS
11h - Vcc +1.25V SUS
12h - Vcc +1.2V SUS
13h - Vcc +1.05V SUS
14h - Vcc +12V
15h - Vcc +5V
16h - Vpp +2.5V
17h - Vddq +1.2V
18h - Vtt Ddr 0.6V
1Eh - PWROK Capture 1
1Fh - PWROK Capture 2
25h - IPMI Watchdog
