mITX-BW – User Guide, Rev. 1.6
www.kontron.com
// 14
8.
Mounting the board in chassis
When mounting the board to chassis etc. please notice that the board contains components
on both sides of the PCB which can easily be damaged if board is handled without
reasonable care. A damaged component can result in malfunction or no function at all.
When fixing the Motherboard on a chassis it is recommended using screws with integrated washer and a
diameter of
>
7 mm. Do not use washers with teeth, as they can damage the PCB and cause short circuits.
2.2.
Requirements IEC60950-1
Take care when designing chassis interface connectors in order to fulfil the IEC60950-1 standard.
Users of mITX-BW must evaluate the end product to ensure compliance the requirements of the IEC60950-1 safety
standard are met:
The motherboard must be installed in a suitable mechanical, electrical and fire enclosure.
The system in its enclosure must be evaluated for temperature and air flow considerations.
The motherboard must be powered by a CSA or UL approved power supply that limits the maximum input current
to 10 A via external barrel-type 12-24 VDC connector, and to 16 A via internal square 12 VDC ATX connector.
For interfaces having a power pin such as external power or fan, ensure that the connectors and wires are
suitably rated. All connections from/to the product shall be with SELV circuits only.
Wires have suitable rating to withstand the maximum available power.
The enclosure of the peripheral device fulfils the fire protecting requirements of IEC60950-1.
2.3.
Lithium battery precautions
Danger of explosion if the lithium battery is incorrectly replaced.
•
Replace only with the same or equivalent type recommended by the manufacturer
•
Dispose of used batteries according to the manufacturer’s instructions
VORSICHT! Explosionsgefahr bei unsachgemäßem Austausch der Batterie.
•
Ersatz nur durch denselben oder einen vom Hersteller empfohlenen gleichwertigen
Typ
•
Entsorgung gebrauchter Batterien nach Angaben des Herstellers
ATTENTION! Risque d'explosion avec l'échange inadéquat de la batterie.
•
Remplacement seulement par le même ou un type équivalent recommandé par le
producteur
•
L'évacuation des batteries usagées conformément à des indications du fabricant
PRECAUCION! Peligro de explosión si la batería se sustituye incorrectamente.
•
Sustituya solamente por el mismo o tipo equivalente recomendado por el fabricante
•
Disponga las baterías usadas según las instrucciones del fabricante
ADVARSEL! Lithiumbatteri – Eksplosionsfare ved fejlagtig håndtering.
•
Udskiftning må kun ske med batteri af samme fabrikat og type
•
Levér det brugte batteri tilbage til leverandøren.
ADVARSEL! Eksplosjonsfare ved feilaktig skifte av batteri.
•
Benytt samme batteritype eller en tilsvarende type anbefalt av apparatfabrikanten.
•
Brukte batterier kasseres i henhold til fabrikantens instruksjoner
VARNING! Explosionsfara vid felaktigt batteribyte.
•
Använd samma batterityp eller en ekvivalent typ som rekommenderas av
apparattillverkaren.
•
Kassera använt batteri enligt fabrikantens instruktion.
VAROITUS! Paristo voi räjähtää, jos se on virheellisesti asennettu.
•
Vaihda paristo ainoastaan lalteval- mistajan suosittelemaan tyyppiln
•
Hävitä käytetty paristo valmistajan ohjeiden mukaisesti
