KBox B-201-CFL - User Guide, Rev. 1.0
// 32
6.3.
Installing and Removing Internal M.2 SSD
To install an M.2 module, perform the following:
1.
Close all applications, shut down the system properly, and disconnect the power source. Disconnect all
peripherals
.
2.
Open the chassis as described in Chapter 6.1: Opening and Closing the Chassis, to open the chassis (steps 1
to 5).
3.
Locate the M.2 socket and the corresponding spacer bolt.
4.
Insert the M.2 module into the M.2 socket, at an angle (approx. 30°). If required, ease the M.2 module into
the socket by moving the module slightly from side to side.
5.
Secure the M.2 Module by pressing down on the free end, and carefully fastening the free end to the
mainboard with an M3x4 screw to the spacer bolt, until the M.2 module is flat with the mainboard.
6.
Close the Chassis as described in Chapter 6.1: Opening and Closing the Chassis, to close the chassis (steps 1
to 4).
After installing or removing a M.2 SSD, the partitioning of the memory maybe different.
To remove an M.2 Module, perform the following:
1.
Close all applications, shut down the system properly, and disconnect the power source. Disconnect all
peripherals.
2.
Open the chassis as described in Chapter 6.1: Opening and Closing the Chassis, to open the chassis (steps 1
to 5).
3.
Locate the installed M.2 module.
4.
Remove the M3x4 screw and the M.2 module springs up at the free end.
5.
Gently pull the M.2 module out of the M.2 socket.
6.
Close the Chassis as described in Chapter 6.1: Opening and Closing the Chassis, to close the chassis (steps 1
to 4).
After installing or removing a M.2 SSD the partitioning of the memory maybe different.
6.4.
Installing and Removing Internal mPCIe Expansion Card
To install a mPCIe card, perform the following:
1.
Close all applications; shut down the system properly and disconnect the power source. Disconnect all
peripherals.
2.
Open the chassis as described in Chapter 6.1: Opening and Closing the Chassis, to open the chassis (steps 1
to 5).
3.
Locate the mPCIe card socket and the corresponding solder nut.
