Kontron EBC2, Manual

Page: 35 / 100

EBC2 Introduction
ID 29022, Rev. 01 © 2005 Kontron Modular Computers GmbH Page 1 - 19
26873
.02.VC.050120/135421
P R E L I M I N A R Y
Communications
Interfaces
CAN INTERFACES
J33 CAN CAN interface (CAN2), 9-pin, male, D-Sub connector, opto-isolated
J34 CAN CAN interface (CAN1), 9-pin, male, D-Sub connector, opto-isolated
OTHER INTERFACES
J16 GPIO General purpose interface, supports EB425 X-Bus and DIO,
shrouded, 50-pin, male, dual pinrow connector
Monitor an
d Control
(M/C)
Interfaces
SWITCH INTERFACES
SW1 Switch Abort switch, generates abort input (interrupt request)
SW2 Switch Reset switch, generates reset input
SW3 Switch HSS operational mode control, selects RS232/422/485 for
SER[1:4]
LED INTERFACES
D2 LED Indicates 12V input power is applied
D4 LED Indicates 5V power is applied
D5 LED Indicates 3.3V power is applied
D9 LED Indicates DIN(0) signal is asserted
D10 LED Indicates DIN(1) signal is asserted
D11 LED Indicates DIN(2) signal is asserted
D12 LED Indicates DIN(3) signal is asserted
D13 LED Indicates DOUT(3) signal is asserted
D14 LED Indicates DOUT(2) signal is asserted
D15 LED Indicates DOUT(1) signal is asserted
D16 LED Indicates DOUT(0) signal is asserted
D17 LED General purpose IO signal, when on signal is asserted (MC11)
D18 LED Indication is a function of the E²Brain™ module Watchdog
logic(MC7)
D19 LED Indication is a function of the NetBootLoader during system
booting, is available to the application after booting is completed
(MC6)
D20 LED Seven segment, hexadecimal display, higher nibble of byte, used
for indicating POST codes or application after system is booted
Table 1-4: EBC2 Main Specifications (Continued)
DESIGNATOR
TYPE Specifications