Kontron COMe Ref. Carrier-i T6 TMIP, User Manual

Page: 20 / 35

COMe Ref. Carrier-i T6 TMI - User Guide Rev. 1.4
www.kontron.com // 20
1.5. Standards
This product complies with the requirements of the following standards.
Table 5: Standards
Type Aspect Standard Comment
CE Emission EN61000-6-3, EN55022
Electrical Safety Directive 2014/35/EU Low Voltage Directive (LVD)
EN60950-1
Product Safety Directive 2001/95/EC General Product Safety Directive
EMC Directive 2014/30/EU Electromagnetic Compatibility
Environmental Climatic Humidity
IEC60068-2-78
[1]
WEEE Directive 2002/96/EC Waste electrical and electronic
equipment
RoHS 2 Directive 2011/65/EU Restriction of the use of certain
hazardous substances in electrical
and electronic equipment
Environmental Vibration (Sinusoidal) IEC60068-2-6 Test parameters:
9-150 (Hz) frequency range 1 (g)
acceleration
1 (oct/min) sweep rate 10
cycles/axis
3 axes
Single Shock IEC60068-2-27 Test parameters:
15 (g) acceleration
11 (ms) shock duration half sine
3 number of shocks per direction
(total: 18)
6 directions
5 (s) recovery time
[1]
Customers desiring to perform further environmental testing of the COMe Ref. Carrier-i T6 TMIP must contact
Kontron for assistance prior to performing any such testing.
Boards without conformal coating must not be exposed to a change of temperature that can lead to condensation, as
it may cause irreversible damage especially when the board is powered up again.
Kontron does not accept any responsibility for damage to products resulting from destructive environmental testing.