886LCD/ATX(GV) -/ATXU(GV)
KTD-00647-C
Public User Manual
Date: 2007-02-08 Page
8 of 71
!
2. Installation
procedure
2.1 Installing the board
To get the board running, follow these steps. In some cases the board shipped from KONTRON Technology
has CPU, DDR DRAM and Cooler mounted. In this case Step 2-4 can be skipped.
1. Turn off the power supply.
2. Insert the DIMM DDR 184pin DRAM module(s). Be careful to push it in the slot(s) before locking the
tabs. For a list of approved DDR DRAM modules contact your Distributor or FAE.
DIMM 184pin DRAM modules are supported.
3. Install the processor. The CPU is keyed and will only mount in the CPU socket in one way. Use the
handle to open/ close the CPU socket. Intel® Pentium® 4, Celeron® and Celeron® D processors are
supported.
4. Use heat paste or adhesive pads between CPU and cooler and connect the Fan electrically to the FAN3
connector. (See chapter 4.1 for identifying the FAN3 connector).
5. Insert all external cables for hard disk, keyboard etc. except for flat panel. A CRT monitor must be
connected in order to change CMOS settings to flat panel support (with ADD-DVO module). To achieve
UDMA-66/100/133 performance on the IDE interface, 80poled UDMA cables
must
be used.
6. Connect power supply to the board by the ATXPWR connector.
7. Turn on the ATX power supply.
8. The PWRSW must be toggled to start the Power supply; this is done by shorting pins pins 19 and 21 on the
CN5 connector (see Connector description). A “normally open” switch can be connected via the CN5
connector.
9. Enter the BIOS setup by pressing the “F2” key during boot up. Refer to the Software Manual for details on
BIOS setup.
Note
: To clear all CMOS settings, including Password protection, move the JP6 jumper (with or without power)
for approximately 1 minute. Alternatively turn off power and remove the battery for 1 minute, but be careful to
orientate the battery corretly when reinserted.
Warning
: Do not use Power Supply without voltage monitoring watchdog, which is
standard feature in ATX Power Supplies.
Running the board without 3.3V connected will damage the board after a few
minuttes.
