Installation Instructions
JRex-IBOX – User’s Manual
35
DIN-Rail Mounting
If the JRex-IBOX is used to be snapped onto a DIN-rail, there is available a
bracket with a DIN-rail-kit.
Please follow these steps for installing the DIN-rail mounting bracket:
1.
The system should be turned off and disconnected from the power source.
2.
To remove the bracket for wall mounting loosen the four screws (two screws
on each side), that secure it to the chassis. Retain the screws for later use.
Fig. 23: Removing the wall mounting brackets from the right and left side of the JRex-IBOX
Fig. 24: Attaching the bracket with the DIN-rail kit to the JRex-IBOX
3.
Install the U-shape bracket with the DIN rail kit and secure it by the four
retained screws (two screws on each side) (
see fig. 23, fig.25, pos. 5
).
Please observe that only the retained M3x4 metric screws may be
used for attaching the bracket with the DIN-rail-kit to the device
